Air UNITS  >   POST-TREATMENT

<!-- 107 -->
POST-TREATMENT

Biokomp compressor stations include post-compression treatment units, such as cyclone filters, coalescing filters, dryers and chillers with condensate drainers which remove liquids, dirt, particles, and other impurities from the compressed gas. Condensate is removed automatically from the gas and conveyed to the outlet so to be safely disposed.The post-compression treatment solutions can range as specified below:

DEHUMIDIFICATION
Gas refrigerant dryers and water chillers specially designed for operation with air, acid, flammable and toxic gases. Stainless steel heat exchangers with automatic drainers. Dessiccant adsorption dryers with activated alumina, silica gels, and molecular sieves.

HEAT RECOVERY
Economizers and heat exchangers designed to recover the compression heat and make it available to an external fluid. Available in different materials and sizes. Tailor-made systems with different temperature and flow options.

OIL REMOVAL
Ultra-fine oil particulate filters and special activated carbon filters for oil removal up to 0,01 mg/m³, according to ISO 8573 requirements for oil-free gases.

GAS CONDITIONING
Post-compression gas conditioning skids, designed to control the gas temperature at discharge within a narrow tolerance range. Complete units with oil heat recovery, heat carrier pump, and programmable temperature control logic.

If you are planning to install one of the following units in your plant, please enter the technical data given in the fields below to submit your enquiry to us. If you need further assistance, feel free to contact us to find out more and receive full information.

checked  DEHUMIDIFICATION  
checked  OIL REMOVAL  
checked  GAS CONDITIONING  
checked  HEAT RECOVERY  

 

up-and-shutDEHUMIDIFICATION

% CH4 - %Vol(*)

% CO2 - %Vol(*)

% O2 - %Vol(*)

% N2 - %Vol(*)

% H2S - %Vol(*)

% NH3 - %Vol

% Siloxanes - mg/m³

H₂O (*)

Relative humidity - % (*)Tip

Gas inlet temperature - °C(*)

Max flow rate - Nm³/h (*)

Gas inlet pressure - bar(g) (*)

Required dew point at discharge - °C (*)

Preferred technology - Gas dryer / Water chiller

 Gas dryer    Water chiller

Available mains power supply - Vac/Hz (*)

Quantity (*)

Note

 

 

up-and-shutOIL REMOVAL

Max flow rate - Nm³/h (*)

Gas inlet pressure - bar(g) (*)

Max oil content at discharge - mg/m³(*)

Oil free gas required (according to ISO 8573 Class1)??

 Yes    No

Quantity (*)

Note

 

 

up-and-shutGAS CONDITIONING

Max flow rate - Nm³/h (*)

Gas inlet pressure - bar(g) (*)

Gas inlet temperature - °C(*)

Gas Outlet temperature - °C(*)

Tolerance range ± - °C

Quantity (*)

Note

 

 

up-and-shutHEAT RECOVERY

Cooling fluid circuit type - Open / Closed (*)

 Open    Closed

Cooling fluid capacity - l/min (*)

Cooling fluid inlet temperature - °C (*)

Cooling fluid outlet temperature - °C

Quantity (*)

Note